-
At 312 m³/h, maintenance is a major concern. You cannot shut down a tower this size for extended periods. You need easy access to internal components. You need quick...
-
Not every installation site is suited for round towers. Sometimes square is better. Square towers fit better in corners. Square towers use space more efficiently in some...
-
Some applications need high flow, high temperature, and a square footprint. The High-temperature Cooling Tower (FMT-100T) meets all three requirements. It delivers 100 m³/h at...
-
In large cooling towers, airflow distribution is often uneven. Some areas of the fill material receive more air than others. Uneven airflow means uneven cooling. Some water is...
-
Moving 300 m³/h of water through a cooling tower requires a lot of air. Standard fans cannot move enough air. Standard towers cannot handle the volume. The Cross Flow Type...
-
Large cooling towers generate vibration. The fans spin. The water falls. The motors run. Vibration transfers to the building structure. It disturbs sensitive equipment. It...
-
At 500 m³/h, you are not buying a cooling tower. You are buying an industrial system. You need maximum capacity. You need maximum reliability. You need maximum engineering. The...
-
Many installation sites have height restrictions. Rooftops with low parapet walls. Indoor mechanical rooms with limited ceiling height. Buildings where a tall cooling tower...
-
You need a cooling tower for a space-constrained site, but you also care about long-term operating costs. Standard side-discharge towers save space, but they do not always save...
-
In a standard cooling tower, water distribution is often uneven. Some areas of the fill receive more water than others. Uneven distribution means some fill surface is wasted....
-
Cooling towers are noisy. Fans generate noise. Water falling generates noise. Motors generate noise. In many locations, noise is regulated. Exceed the limit, and you face...
-
Some sites are extremely noise-sensitive. Luxury hotels. High-end office buildings. Residential complexes. Research facilities. In these locations, even 65 dB(A) is too loud....
Jun 06, 2020 · The crossflow cooling tower belongs to the family of mechanical drift cooling towers in which the upward flow of the air cools down the hot...
More than 50 years of experience and success have made us a major global player in planning and implementation of wet cooling towers. Our Competence Center for wet cooling towers can offer any type...
Cross flow cooling tower is a cooling device that is designed to remove the heat of the process fluid, thereby cooling the process fluid. With tubular exchangers placed in the tower, the whole...
We offer fill depths of 300 and 600 mm. Combinations of these allow different installation depths (e.g. 300 + 600 = 900 mm). In most crossflow cooling towers the fills are vertically installed at...
Mar 29, 2018 · Crossflow cooling tower: In crossflow cooling tower water enters perpendicularly while air enters for the side walls of the tower horizontally and then rise upward from the center of...
Jun 01, 2010 · A differential element of a cross flow cooling tower. Rearranging Eq. (1) results in the following set of PDEs for the variations of water temperature and air enthalpy throughout...












